polyformes foam solutions
cta
LinkedIn iconTwitter iconFacebook iconPinterest icon 01525 852444

Zotek N | High Temperature Foams

You are Here:
Materials : Materials : Zotek N High Temperature Foam

Zotek N


 About Zotek N High temperature foams

Benefits of Zotek N high temp foam

ZOTEK® N - is the worlds only low density polyamide foam

 Zotek N forming and shaping

It is a closed-cell crosslinked polyamide (nylon) foam for use in higher temperatures environments (200°C+) and is available in a range of densities. Compared to other foams ZOTEK® N has a significantly higher upper operating temperature limit. Thermal shrinkage at 205 deg °C can be less than 5% after 24 hours. This allows ZOTEK® N to be used in systems requiring high temperature processing such as composite cores or in-line paint systems.

ZOTEK® N is excellent thermal insulator and will act as heat shield - which can be further enhanced by the addition of an aluminium layer. ZOTEK® N is fully compliant with R.O.H.S & REACH requirements. It is lightweight (from 30kg/m density) and thus ZOTEK® N materials offer many weight saving and energy saving advantages.

Zotek N gaskets and liners

Based on polyamide (nylon), ZOTEK® N has excellent general chemical resistance and is exceptionally resistant to hydrocarbons including fuels, oils, brake and power steering fluids, and antifreeze. Being a closed cell material, acoustic insulation is very good, with good noise, isolation and damping characteristics. It can be used in combination with other materials to optimise acoustic performance.

Impact and energy absorption is also high and  ZOTEK® N has good kinetic mechanical energy absorption properties. There is little rebound when compared to other common foam.ZOTEK® NB50 electrical conductivity - a typical surface resistance of 1 x 1012 ohms which classifies the material as insulative according to the ESD Association.

Being based on a polyamide material,  ZOTEK® N has naturally good UV resistance characteristics. After 1000 hour exposure there is minimal effect on tensile strength and elongation at break.

With regard to flammability ZOTEK® N meets typical horizontal burn requirements of FMVSS302 above 4mm thickness.

Specialist Aircraft Foam Materials - Click on this link to go to the highest FST performance aerospace foams page

If you have a particular requirement for high temperature foams and would like to discuss your application, please call us - our Technical Department would be pleased to assist.

Sony logoJaguar Logoqinetiq logoHarrods LogoV&A Logo

Home | Site Map | Privacy & Cookie Policy | Terms & Conditions

Polyformes Limited
Cherrycourt Way,
Leighton Buzzard,
Bedfordshire,
LU7 4UH.

Company registration number 1296564.


Vat Number GB 432 9927 28

© 2017 Polyformes Ltd.

 

museums association corportate memberLRQA UKAS

www.intergage.co.uk